Asus M4A78T-E - Motherboard - ATX - Page 56

2-36
Chapter 2: Hardware information
Chapter 2
1. Connect the front panel cables to the ASUS
Q-Connector.
Refer to the labels on the Q-Connector to know the
detailed pin denitions, and then match them to
their respective front panel cable labels.
The labels on the front panel cables
may vary depending on the chassis
model.
2. Install the ASUS Q-Connector to the system panel
connector, making sure the orientation matches the
labels on the motherboard.
3. The front panel functions are now enabled. The
gure shows the Q-Connector is properly installed
on the motherboard.
IDE_LED
POWER SW
RESET SW
IDE_LED-
IDE_LED+
PWR
Reset
Ground
Ground
14. ASUS Q-Connector (system panel)
Use the ASUS Q-Connector to connect/disconnect the chassis front panel cables.
To install the ASUS Q-Connector