Asus MAXIMUS III FORMULA - Storage Configuration

ROG Maximus III Formula 3-19


Configure SATA as [IDE]


• If you want to use the Serial ATA hard disk drives as Parallel ATA physical
storage devices, keep the default setting [IDE].
• If you want the Serial ATA hard disk drives to use the Advanced Host
Controller Interface (AHCI), set this item to [AHCI]. The AHCI allows
the onboard storage driver to enable advanced Serial ATA features that
increases storage performance on random workloads by allowing the drive

• If you want to create a RAID 0, RAID 1, RAID 5, RAID 10, or the Intel
®

drives, set this item to [RAID].
Hard Disk Write Protect [Disabled]
Disables or enables device write protection. This will be effective only if the device

IDE Detect Time Out (Sec) [35]

[0] [5] [10] [15] [20] [25] [30] [35]
 

devices installed in the system. Select an item then press <Enter> if you want to

BIOS SETUP UTILITY
Main
Storage Conguration
SATA Conguraton [Enhanced]
Congure SATA as [IDE]
Hard Disk Write Protect [Disabled]
IDE Detect Time Out (Sec) [35]
Options
Disabled
Enabled