3-40 Chapter 4: BIOS setup
3.7.3 BIOS Boot Priority
• This item appears only when you move the BIOS_FLASHBACK jumper
cap to pins 1-2: BIOS MENU.
• Refer to 2. BIOS ash setting (6-pin BIOS_FLASHBACK) in 2.6
Jumpers for further information.
Now BIOS status
Shows “BIOS1” or “BIOS2” depending on from which BIOS the system boots.
BIOS Boot Selection
Shows “BIOS Menu” to indicate that you make BIOS bootup selection through
BIOS menu rather than by moving the BIOS_FLASHBACK jumper cap.
Forced BIOS Boot from
Allows you to select from which BIOS the system boots. Highlight [BIOS1] or
[BIOS2] and press <Enter>, and the system will reboot.
Select Screen
Select Item
Enter Go to Sub Screen
F1 General Help
F10 Save and Exit
ESC Exit
v02.58 (C)Copyright 1985-2008, American Megatrends, Inc.
Now BIOS status : BIOS1
BIOS Boot Selection : BIOS Menu
Forced BIOS Boot from
BIOS1
BIOS2
BIOS1
BIOS SETUP UTILITY
Boot
To Next Page
Loading...
