Asus MAXIMUSII/FORMULA - Maximus II Formula Motherboard - Page 46

2-20 Chapter 2: Hardware information
2. BIOS ash setting (6-pin BIOS_FLASHBACK)
Two sets of BIOS Flash ROM (BIOS 1 and BIOS 2) are present on this
motherboard. This jumper allows you to select either BIOS as the one to boot,
or back up or restore BIOS content from one ROM to the other.
Moving the jumper cap to
pins 1-2 (default)
allows you to enter
BIOS MENU
to select which BIOS to boot.
Moving the jumper cap to
pins 3-4
enables the system to boot from
BIOS 1
.
Moving the jumper cap to
pins 5-6
enables the system to boot from
BIOS 2
.
BIOS LED
When the BIOS backup starts, the system will enter the soft-off state and the
BIOS LED will blink to indicate that the backup is proceeding.
Refer to
3.7.3 BIOS Boot Priority
for further information.
Refer to
3.8.3 BIOS Flashback
for further information.