Asus MAXIMUSII/FORMULA - Maximus II Formula Motherboard - Page 99

ASUS Maximus II Formula 3-31
ROG Logo [Enabled]
If this item is set to [Enabled], the box labeled as Republic of Gamers on the
heatpipe assembly lights up when the system is on.
Conguration options: [Enabled] [Disabled]
LCD Poster Backlight [Disabled]
Allows you to turn on/off the LCD Poster backlight after POST.
Conguration options: [Turn On] [Turn Off]
LCD Poster Mode [HWM Information]
Allows the LCD Poster to display either hardware information or time.
Conguration options: [Current Time] [HWM Information]
The following item becomes congurable when you set LCD Poster Mode to
[HWM Information].
HWM Select Mode
Allows you to select which hardware information to display on the LCD
Poster. Conguration options: [All Voltage] [All Temperature] [All Fan Speed]
Voltiminder LED [Enabled]
Allows you to enable or disable the onboard Voltiminder LED.
Conguration options: [Enabled] [Disabled]
CPU LED Selection [Vcore]
Allows you to switch the onboard CPU LED display between CPU voltage
[Vcore] and CPU PLL voltage [CPU PLL].
Conguration options: [Vcore] [CPU PLL]
NB LED Selection [NB]
Allows you to switch the onboard northbridge LED display between North Bridge
Voltage [NB] and FSB Termination Voltage [VTT].
Conguration options: [NB] [VTT]
SB LED Selection [SB 1.1]
Allows you to switch the onboard southbridge LED display between South Bridge
1.1 Voltage [SB 1.1] and South Bridge 1.5 Voltage [SB 1.5].
Conguration options: [SB 1.1] [SB 1.5]