Asus P5KPL-CM 1600 - ASUS EZ Flash 2 Utility

Chapter 2: BIOS setup 2-3
Note
ASUSTek EZ Flash 2 BIOS ROM Utility V3.25
Current ROM
Update ROM
A:
FLASH TYPE: MXIC 25L8005
PATH: A:\
BOARD: P5KPL-AM/PS
VER: 0003
DATE: 07/22/08
BOARD: Unknown
VER: Unknown
DATE: Unknown
[Enter] Select or Load [B] Backup [ESC] Exit
[Tab] Switch [Up/Down/Home/End] Move
Note
2.1.3 ASUS EZ Flash 2 utility
The ASUS EZ Flash 2 feature allows you to update the BIOS without having to use a
bootable oppy disk or an OS-based utility.
• Enter the BIOS setup program. Go to the
Tools menu to select EZ Flash 2 and
press <Enter> to enable it.
2. Press
<Tab> to switch between drives until the correct BIOS le is found, then press
<Enter>. EZ Flash 2 performs the BIOS updating process and automatically reboots
the system when done.
• This function can support devices such as USB ash disk, or oppy disk with FAT 32/16
format and single partition only.
• Do not shut down or reset the system while updating the BIOS to prevent system boot
failure!
Before using this utility, download the latest BIOS le from the ASUS website at www.asus.
com.
To update the BIOS using EZ Flash 2:
1. Insert the oppy/USB ash disk that contains the latest BIOS le to the oppy disk
drive or the USB port, then launch EZ Flash 2. You can launch EZ Flash 2 in two ways.
a. Press
<Alt> + <F2> during POST to display the following: