1.7 Connectors
1.7.1 Rear panel ports
3. Keyboard/mouse power (3-pin KBPWR)
This jumper allows you to enable or disable the keyboard/mouse and USB port 5-6
wake-up feature. When you set this jumper to pins 2-3 (+5VSB), you can wake up the
computer by pressing a key on the keyboard (the default is the Space Bar), clicking
the mouse, or using a USB device. This feature requires an ATX power supply that can
supply at least 1A on the +5VSB lead, and a corresponding setting in the BIOS. The
USBPW56 jumper is for the rear USB ports.
P5KPL IN/SI
P5KPL IN/SI
P5KPL IN/SI
Keyboard Power Setting
21
2 3
+5V
(Default)
+5VSB
KBPWR
1. PS/2 mouse port (green). This port is for a PS/2 mouse.
2. LAN (RJ-45) port
. This port allows Gigabit connection to a Local Area Network (LAN)
through a network hub.
LAN port LED indications
SPEED
LED
ACT/LINK
LED
LAN port
Activity/Link LED Speed LED
Status Description Status Description
OFF No link OFF 10 Mbps connection
Yellow Linked ORANGE 100 Mbps connection
BLINKING Data activity GREEN 1 Gbps connection
Chapter 1: Product introduction 1-8
To Next Page
Loading...
