Asus P5LD2 SE - Page 86

4-26 Chapter 4: BIOS setup
Hyper Path 3 [Auto]
Allows you to enable or disable the ASUS Hyper Path 3 feature.
Conguration options: [Disabled] [Enabled] [Auto]
DRAM Throttling Threshold [Auto]
Allows you to set DRAM throttling threshold to auto or disabled.
Conguration options: [Disabled] [Auto]
Boot Graphic Adapter Priority [PCI Express/PCI]
Allows selection of the graphics controller to use as primary boot device.
Conguration options: [PCI Express/PCI] [PCI/PCI Express]
PEG Buffer Length [Auto]
Sets the length of the PCI Express graphics card buffer.
Conguration options: [Auto] [Long] [Short]
Link Latency [Auto]
Sets the PCI Express graphics card link latency.
Conguration options: [Auto] [Slow] [Normal]
PEG Root Control [Auto]
Allows you to enable, disable, or set to automatic the PCI Express graphics
card root control. Conguration options: [Auto] [Disabled] [Enabled]
PEG Link Mode [Auto]
Sets the PCI Express graphics link mode. Setting this item to [Auto]
allows the motherboard to automatically adjust the PCI Express graphics
link mode to the correct frequency based on the system conguration.
Four additional settings are available for overclocking the PEG Link Mode.
Conguration options: [Auto] [Slow] [Normal] [Fast] [Faster]
Slot Power [Auto]
Sets the PCI Express graphics card slot power.
Conguration options: [Auto] [Light] [Normal] [Heavy] [Heavier]
High Priority Port Select [Disabled]
Allows you to disable or select the high priority port. The specied high
priority port will be given arbitration above VC0 but below VC1.
Conguration options: [Disabled] [PCI Express Port 4]