5-38 Chapter 5: Software support
Exiting the Intel
®
Matrix Storage Manager utility
To exit the utility:
1. From the utility main menu, select 4. Exit, then press <Enter>. This
window appears.
Are you sure you want to exit? (Y/N):
[ CONFIRM EXIT ]
2. Press <Y> to exit or press <N> to return to the utility main menu.
Resetting Disks to Non-RAID
Take caution before you reset a RAID volume HDD to non-RAID. Resetting
a RAID volume HDD deletes all internal RAID structure on the drive.
To reset a RAID set hard disk drive:
1. From the utility main menu, select 3. Reset Disks to Non-RAID, then
press <Enter> to display this screen.
2. Use the up/down arrow key to highlight the RAID set drive you want
to reset, then press <Space> to select.
3. Press <Enter> to reset the RAID set drive. A conrmation message
appears.
4. Press <Y> to reset the drive or press <N> to return to the utility main
menu.
[ RESET RAID DATA ]
Resetting RAID data will remove internal RAID structures
from the selected RAID disks. By removing these structures,
the drive will revert back to a non-RAID disk.
WARNING: Resetting a disk causes all data on the disk to be lost.
Port Drive Model Serial # Size Status
0 XXXXXXXXXXXX XXXXXXXX XX.XGB Member Disk
1 XXXXXXXXXXXX XXXXXXXX XX.XGB Member Disk
Select the disks that should be reset.
[↑↓]-Previous/Next [SPACE]-Selects [ENTER]-Selection Complete
To Next Page
Loading...
