Asus P5WDG2 WS Professional - ASUS EZ Flash 2 Utility

ASUS P5WDG2 WS Professional/P5WDG2 WS PRO/WiFi-AP 4-5
4.1.3 ASUS EZ Flash 2 utility
The ASUS EZ Flash 2 feature allows you to update the BIOS without having
to go through the long process of booting from a oppy disk and using
a DOS-based utility. The EZ Flash 2 utility is built in the BIOS chip so it is
accessible by pressing <Alt> + <F2> during the Power-On Self-Test (POST).
To update the BIOS using EZ Flash 2:
1. Visit the ASUS website (www.asus.com) to download the latest BIOS
le for the motherboard and rename the same to WDG2WSP.ROM.
2. Save the BIOS le to a oppy disk or a USB ash disk, then restart the
system.
3. You can launch the EZ Flash 2 by two methods.
(1) Insert the oppy disk / USB ash disk that contains the BIOS le
to the oppy disk drive or the USB port.
Press <Alt> + <F2> during POST to display the following.
• This function can supp ort devices such as USB ash disk, or oppy
disk with FAT 32/16 format and single partition only.
• Do not shutdown or reset the system while updating the BIOS to
prevent system boot failure!
4. When the correct BIOS le is found, EZ Flash 2 performs the BIOS
update process and automatically reboots the system when done.
(2) Enter BIOS setup program. Go th the Tools menu to select EZ
Flash 2 and press <Enter> to enable it.
You can switch between drives by pressing <Tab> before the
correct le is found. Then press <Enter>.
ASUSTek EZ Flash 2 BIOS ROM Utility V3.00
Current ROM Update ROM
BOARD: P5WDG2-WS Pro
VER: 0204
DATE: 07/04/2006
BOARD: Unknown
VER: Unknown
DATE: Unknown
[Enter] Select [S] Save [ESC]Exit
[Tab] Switch [Up/Down/Home/End] Move
Note
FLASH TYPE: Winbond W39V080A 8Mb LPC
PATH: A:\