Asus P6T6 WS Revolution - ASUS Q-Connector

ASUS Q-Connector (system panel)
You can use the ASUS Q-Connector to connect/disconnect chassis front panel
cables in a few steps. Refer to the instructions below to install the ASUS
Q-Connector.
1. Connect the front panel cables to
the ASUS Q-Connector.
Refer to the labels on the
Q-Connector to know the detailed
pin denitions, then match them
to the respective front panel cable
labels.
2. Install the ASUS Q-Connector
to the system panel connector,
making sure the orientation
matches the labels on the
motherboard.
3. The front panel functions are now
enabled. The gure shows the
Q-Connector properly installed on
the motherboard.
IDE_LED
POWER SW
RESET SW
IDE_LED-
IDE_LED+
PWR
Reset
Ground
Ground
The labels on the front panel cables
may vary depending on the chassis
model.
2-34 Chapter 2: Hardware information