Asus P6T6 WS Revolution - DRAM Frequency [Auto]; UCLK Frequency [Auto]; QPI Frequency [Auto]; DRAM Timing Control [Auto]

3-16 Chapter 3: BIOS setup
3.4.5 DRAM Frequency [Auto]
Allows you to set the DDR3 operating frequency.
Conguration options: [Auto] [DDR3-800MHz] [DDR3-1066MHz]
The DRAM Frequency conguration options vary with the BCLK Frequency
item settings.
Selecting a very high DRAM frequency may cause the system to become
unstable! If this happens, revert to the default setting.
3.4.6 UCLK Frequency [Auto]
Allows you to set the Uncore Clock Ratio (UCLK).
Conguration options: [Auto] [DDR3-1600MHz] [DDR3-2033MHz]
The UCLK Frequency conguration options vary with the DRAM Frequency
item settings.
3.4.7 QPI Frequency [Auto]
Allows you to set the QuickPath Interconnect (QPI) frequency.
Conguration options: [Auto] [4331MHz] [5293MHz] [5774MHz]
3.4.8. DRAM Timing Control [Auto]
The items in this menu allow you to set the DRAM timing control features.
The conguration options for some of the following items vary depending on the
DIMMs you install on the motherboard.
1st Information: 6-6-6-15-4-36-6-3-16-4
The values vary depending on your settings of the following sub-items:
DRAM CAS# Latency [Auto]
Conguration options: [Auto] [3 DRAM Clock] [4 DRAM Clock] – [10 DRAM
Clock] [11 DRAM Clock]
DRAM RAS# to CAS# Delay [Auto]
Conguration options: [Auto] [3 DRAM Clock] [4 DRAM Clock] – [9 DRAM
Clock] [10 DRAM Clock]
DRAM RAS# PRE Time [Auto]
Conguration options: [Auto] [3 DRAM Clock] [4 DRAM Clock] – [9 DRAM
Clock] [10 DRAM Clock]
DRAM RAS# ACT Time [Auto]
Conguration options: [Auto] [3 DRAM Clock] [4 DRAM Clock] – [32 DRAM
Clock] [33 DRAM Clock]
DRAM RAS# to RAS# Delay [Auto]
Conguration options: [Auto] [1 DRAM Clock] – [15 DRAM Clock]