Asus P6T7 WS SuperComputer - Motherboard - SSI CEB - ASUS Q-Connector (System Panel)

2.7.3. ASUS Q-Connector (system panel)
Use the ASUS Q-Connector to connect/disconnect the chassis front panel cables.
1. Connect the front panel cables to the
ASUS Q-Connector.
Refer to the labels on the Q-Connector
to know the detailed pin denitions, and
then match them to their respective
front panel cable labels.
The labels on the front panel
cables may vary depending on
the chassis model.
IDE_LED
POWER SW
RESET SW
IDE_LED-
IDE_LED+
PWR
Reset
Ground
Ground
2. Install the ASUS Q-Connector to the
system panel connector, ensuring the
orientation matches the labels on the
motherboard.
3. The front panel functions are now
enabled. The gure shows the
Q-Connector is properly installed on the
motherboard.
ASUS P6T7 WS SuperComputer 2-33