Asus P7H55-M - Uncore Configuration; Onboard Devices Configuration

2-20 ASUS P7H55-M/USB3
2.5.2 Uncore Conguration
The North Bridge Conguration menu allows you to change the advanced chipset settings.
Memory Remap Feature [Enabled]
[Disabled] Do not allow remapping of memory.
[Enabled] Allows for the segment of system memory that was previously
overwritten by PCI devices to be remapped above the total physical
memory.
Initiate Graphic Adapter [PCIE/PCI]
Allows you to select the graphics controller as the primary boot device.
Conguration options: [PCI/PCIE] [PCIE/PCI]
2.5.3 Onboard Devices Conguration
HDA Controller [Enabled]
Enables or disables the High Denition Audio Controller.
Conguration options: [Enabled] [Disabled]
Front Panel Type [HD Audio]
Set the front panel audio connector (AAFP) mode.
Conguration options: [AC97] [HD Audio]
Realtek LAN [Enabled]
[Enabled] Enables the Realtek LAN controller.
[Disabled] Disables the controller.
LAN Boot ROM [Disabled]
This item appears only when you set the previous item to [Enabled].
[Enabled] Enables the Realtek Gigabit LAN Boot ROM.
[Disabled] Disables the LAN Boot ROM.
Serial Port1 Address [3F8/IRQ4]
Allows you to select the Serial Port1 base address.
Conguration options: [Disabled] [3F8/IRQ4] [2F8/IRQ3] [3E8/IRQ4] [2E8/IRQ3]
Parallel Port Address [378]
Allows you to select the Parallel Port base addresses. Conguration options: [Disabled] [378]
[278] [3BC]
Parallel Port Mode [Normal]
Allows you to select the Parallel Port mode.
Conguration options: [Normal] [Bi-Directional] [EPP] [ECP] [ECP & EPP]
ECP Mode DMA Channel [DMA3]
Appears only when the Parallel Port Mode is set to [ECP] or [ECP & EPP]. This item
allows you to set the Parallel Port ECP DMA. Conguration options: [DMA0] [DMA1]
[DMA3]