6-8
Chapter 6: Intel
®
technologies
Chapter 6
Recovering the partition
This procedure allows you to delete the Intel
®
Rapid Start Technology from your system, and
recover the partition you made for the Intel Rapid
®
Start Technology installation.
1. Run the
Command Prompt tool.
2. Type
diskpart and press <Enter>.
3. At the diskpart prompt, type
list disk after DISKPART, and
press <Enter>.
Click to enable or disable
battery saving mode. This
function only applies to
notebooks.
Select and click to enable or
disable the function
Click to enable or disable the timer. When enabled, move the scroll
bar to the desired time. When the system is idle for more than the
time period you set, the system automatically goes into the Intel
®
Rapid Start mode. Default time is 10 minutes.
Click to save the
settings made.
Click to cancel the
settings made.
2. Tick On in the Status eld to enable the function, and click Save.
4. Select the disk (SSD)
where the Intel
®
Rapid Start
Technology is installed for
volume recovery, type select
disk x (x = number), and press
<Enter>.
The value “x” refers to a disk number where you want to delete the store partition.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
