Asus PA248QV Series - Connecting the Cables

2-3ASUS PA248QV Series LCD Monitor
90°
90°
It is normal that the monitor slightly shakes while you adjust the viewing angle.
2.4 Connecting the cables
Connect the cables as the following instructions:
 : Connect one end of the power cord securely to
the monitor’s AC input port, the other end to a power outlet.
 :
a. Plug one end of the VGA/DisplayPort/HDMI cable to the monitor’s VGA/
DisplayPort/HDMI jack.
b. Connect the other end of the VGA/DisplayPort/HDMI cable to your
computer's VGA /DisplayPort/HDMI jack.
c. Tighten the two screws to secure the VGA connector.
 connect one end of the audio cable to the
monitor’s Audio-in port, the other end to the computer’s audio-out port.
  connect the end with plug type to the monitor’s
earphone jack when an HDMI/DisplayPort signal is fed.
 :
»
Upstream: Use the supplied USB Type-B to Type-A cable. Make sure
your computer is installed with the latest Windows 7/Windows 8.1/
Windows 10 operating system. That will enable the USB ports on the
monitor to work.