2-4 Chapter 2: Setup
Be careful not to touch or press the screen area when adjusting the monitor.
2.4 Connecting the cables
Connect the cables as the following instructions.
For service only
: Connect one end of the power cord securely to
the monitor’s AC input port, the other end to a power outlet.
:
a. Plug one end of the HDMI/DisplayPort cable to the monitor’s HDMI/
DisplayPort jack.
b. Connect the other end of the HDMI/DisplayPort cable to your device's
HDMI/DisplayPort jack.
connect the end with plug type to the monitor’s
earphone jack when an HDMI/DisplayPort/Thunderbolt signal is fed.
:
»
Upstream: Use the supplied USB Type-C to Type-A cable or
Thunderbolt cable and plug the Type-C or Thunderbolt connector to the
monitor's Thunderbolt port as upstream, and the other side (Type-A or
Thunderbolt) to your computer port. Make sure your computer is installed
with the latest Windows 7/Windows 8.1/Windows 10 operating system.
That will enable the USB ports on the monitor to work.
To Next Page
Loading...
Need help?
General