Asus PRIME Z270-P - Hard Disk Drive Activity LED (2-Pin +HDD_LED-); System Panel Connector; System Power LED (4-Pin +PWR_LED-); System Warning Speaker (4-Pin SPEAKER)

ASUS PRIME Z270-P
1-21
• SystempowerLED(4-pin+PWR_LED-)
This4-pinconnectorisforthesystempowerLED.ConnectthechassispowerLED
cabletothisconnector.ThesystempowerLEDlightsupwhenyouturnonthesystem
power,andblinkswhenthesystemisinsleepmode.
• HarddiskdriveactivityLED(2-pin+HDD_LED-)
This2-pinconnectorisfortheHDDActivityLED.ConnecttheHDDActivityLEDcable
tothisconnector.TheHDDLEDlightsuporasheswhendataisreadfromorwritten
totheHDD.
• Systemwarningspeaker(4-pinSPEAKER)
This4-pinconnectorisforthechassis-mountedsystemwarningspeaker.Thespeaker
allows you to hear system beeps and warnings.
• ATXpowerbutton/soft-offbutton(2-pinPWR_SW)
This connector is for the system power button. Pressing the power button turns the
system on or puts the system in sleep or soft-off mode depending on the operating
system settings. Pressing the power switch for more than four seconds while the
systemisONturnsthesystemOFF.
• Resetbutton(2-pinRESET)
This 2-pin connector is for the chassis-mounted reset button for system reboot without
turning off the system power.
10. System panel connector
Thisconnectorsupportsseveralchassis-mountedfunctions.
* Requires an ATX power supply
PLED+ PLED- PWR GND +5V GND GND Speaker
HDD_LED+
HDD_LED-
GND
RESET
NC
PLED+
PLED-
PIN 1
+PWR_LED-
+PWR_LED-
SPEAKER
PANEL
+HDD_LED-
PWR_SW
RESET
PRIME Z270-P System panel connector
PRIME Z270-P