3-10
Chapter 3: General Instruction
• USB Setup: Sets the USB Hub availability during standby.
• Power Indicator: Turns the power LED indicator on/off.
• Power Key Lock: Disables or enables the power key.
• Key Lock: Enable this function to disable all function keys.
Press the button down for more than ve seconds to cancel
the key lock function.
• Screen Protection:
• Screen Saver: Disables or enables the screen saver
function. The screen brightness will automatically
decrease when there is no change on the screen.
• Pixel Cleaning: It calibrates any issues that may arise on
the screen when your monitor has been turned on for a
long time. The process will take approximately 6 minutes.
This function will automatically activate when the monitor
is turn off. Do not unplug the power cord while it is in
progress. If you power on the monitor, the Pixel Cleaning
will stop operating.
• Screen Move: Selects the screen movement level to
prevent image sticking on the display panel.
• Adjust Logo Brightness: Enables this function to allow
the system to automatically adjust the logo brightness to
correct the potential picture quality issues.
• Pixel Cleaning Cycle Reminder: Sets a reminder for user to
perform the Pixel Cleaning.
• The screen may have mura and image sticking due to OLED characteristic
during the initial use or re-used after a long time. It is advised to perform Pixel
Cleaning while turning on monitor to make sure situation disappear.
• Power Setting: Select the power setting between Standard
Mode and Power Saving Mode.
• In Power saving mode, the screen brightness will be lowered and the
monitor will consume less power. If you need to keep higher brightness
level then set the Power Setting to Standard mode.
• Please turn off HDR function before activating the Power Saving Mode.
To Next Page
Loading...
Need help?
General
