Asus TUF Z370-PLUS GAMING - APM Configuration

ASUS TUF Z370-PLUS GAMING
3-27
Chapter 3
Hyper M.2X16
[Disable] Only one SSD installed onto the Hyper M.2 X16 card can be detected.
[Enable] Two or three SSDs installed onto the Hyper M.2 X16 card can be detected.
The number of SSDs that can be detected varies with the congurations of the PCIe X16
slots.
ASMedia USB 3.1 Controller
This item allows you to enable or disable the ASMedia USB 3.1 Controller.
Conguration options: [Disabled] [Enabled]
RGB LED lighting
When system is in working state
This item allows you to turn on or turn off the RGB LED lighting when the system in working
state. Conguration options: [On] [Off]
When system is in sleep, hibernate or soft off state
[On] LEDs will light up in S3 (sleep), S4 (hibernat) and S5 (soft off) states.
[Off] LEDs will not light up in S3 (sleep), S4 (hibernat) and S5 (soft off) states.
Intel LAN Controller
This item allows you to enable or disable the Intel LAN controllers.
Conguration options: [Disabled] [Enabled]
Intel PXE Option ROM
This item only appears when the item Intel LAN Controller is set to [Enabled]. This item
allows you to enable or disable the Intel PXE Option ROM. Conguration options: [Enabled]
[Disabled]
USB Type C Power Switch
[Auto] Switch off the Type C power if the device is not supported.
[Enabled] Switch on the Type C power for the device.
3.6.8 APM Configuration
The items in this menu allow you to set system wake and sleep settings.
ErP Ready
This item allows you to switch off some power at S4+S5 or S5 to get the system ready for
ErP requirement. When set to [Enabled], all other PME options are switched off.
Conguration options: [Disabled] [Enable(S4+S5)] [Enable(S5)]
Restore AC Power Loss [Power Off]
[Power On] The system goes into on state after an AC power loss.
[Power Off] The system goes into off state after an AC power loss.
[Last State] The system goes into either off or on state, whatever the system state was
before the AC power loss.