Asus VG245HE - 2.3 Detaching the Arm (for VESA Wall Mount); 2.4 Connecting the Cables

2-2 Chapter 2: Setup
2.3 Detaching the arm (for VESA wall
mount)
The detachable arm/base of this monitor is specially designed for VESA wall
mount.
To detach the arm/base:
1. Have the front of the monitor face down on a table.
2. Remove the rubbers in the four screw holes. (Figure 1)
3. Remove the base (Figure 2).
4. Use a screwdriver to remove the screw on the hinge (Figure 3), then remove
the hinge.
1
2
2
1
(Figure 1) (Figure 2) (Figure 3)
We recommend that you cover the table surface with soft cloth to prevent
damage to the monitor.
2.4 Connecting the cables
Connect the cables as the following instructions: