Asus VP279 Series - Page 18

2-1
Chapter 2: Setup
VP279QGL
To detach the base, perform the following:
1. Disconnect power and signal cables. Carefully put the front of the
monitor face down on a clean table.
2. Loosen the 4 screws securing the arm.
3. Remove the stand assembly (arm and monitor base).
4. Align and install the wall mount bracket on the rear of the monitor.
Screw holes for VESA wall mount
(100 x 100 mm)
• Werecommendthatyoucoverthetablesurfacewithsoftclothtoprevent
damage to the monitor.
• The VESA wall mount kit ( 100 x 100 mm) is purchased separately.
• UseonlytheULListedWallMountBracketwithminimumweight/load
22.7kg (Screw size: M4 x 10 mm).