Asus VP279 Series - Detaching the Base (for VESA Wall Mount)

1-8
ASUS LCD Monitor VP279 Series
2.1 Detaching the Base (for VESA Wall
Mount)
VP279QG
To detach the base, perform the following:
1. Disconnect power and signal cables. Carefully put the front of the
monitor face down on a clean table.
2. Turn the screw counter-clockwise to loosen the screw located at the
bottom of the base.
3. Remove the base from the stand assembly.
4. Remove the stand cover. Then loosen the 4 screws to remove the
arm.
5. Align and install the wall mount bracket on the rear of the monitor.
Screw holes for VESA wall mount
(100 x 100 mm)
• Werecommendthatyoucoverthetablesurfacewithsoftclothtoprevent
damage to the monitor.
• Hold the base while removing the screw.
• The VESA wall mount kit ( 100 x 100 mm) is purchased separately.
• UseonlytheULListedWallMountBracketwithminimumweight/load
22.7kg (Screw size: M4 x 10 mm).