Asus WS C246M PRO - Device Power-Up Delay; Mass Storage Devices; 3.4.13 Network Stack Configuration

3-22
Chapter 3: BIOS Setup
Chapter 3
Device power-up delay [Auto]
Allowsyoutosetthemaximumtimethedevicetakesbeforethedevicereportsitselftothe
host controller properly.
Congurationoptions:[Auto][Manual]
The following item appears only when you set Device power-up delay to [Manual].
Device power-up delay in seconds [5]
Allows you to set the device power-up delay in seconds. Use the <+> or <-> to adjust
the value. The values range from 1 to 40.
Mass Storage Devices
Allows you to select the mass storage device emulation type for devices connected.
Congurationoptions:[Auto][Floppy][ForcedFDD][HardDisk][CD-ROM]
3.4.13 Network Stack Configuration
Allowsyoutocongurethenetworkstackconguration.
Network Stack [Disabled]
AllowsyoutoenableordisableUEFINetworkStack.
Congurationoptions:[Disabled][Enabled]
The following items appear only when you set Network Stack to [Enabled].
Ipv4 PXE Support [Disabled]
Enables or disables the Ipv4 PXE Boot Support. If disabled, Ipv4 PXE boot option will
not be created.
Congurationoptions:[Disabled][Enabled]
Ipv4 HTTP Support [Disabled]
Enables or disables the Ipv4 HTTP Boot Support. If disabled, Ipv4 PXE boot option will
not be created.
Congurationoptions:[Disabled][Enabled]
Ipv6 PXE Support [Disabled]
Enables or disables the Ipv6 PXE Boot Support. If disabled, Ipv6 PXE boot option will
not be created.
Congurationoptions:[Disabled][Enabled]
Ipv6 HTTP Support [Disabled]
Enables or disables the Ipv6 HTTP Boot Support. If disabled, Ipv6 PXE boot option will
not be created.
Congurationoptions:[Disabled][Enabled]