Asus WS C422 SAGE/10G - Installing Three Crossfirex Graphics Cards

ASUS WS C422 SAGE/10G
5-3
Chapter 5
5. Connect two independent auxiliary
power sources from the power supply
to the two graphics cards separately.
6. ConnectaVGAoraDVIcabletothe
graphics card.
5.1.4 Installing three CrossFireX™ graphics cards
To install three CrossFireX™ graphics cards:
1. Prepare three CrossFireX™-ready graphics cards.
2. Insert the three graphics card into the PCIEX16 slots. If your motherboard has more
than three PCIEX16 slots, refer to Chapter 1 in this user manual for the locations of the
PCIEX16 slots recommended for multi-graphics card installation.
3. Ensure that the cards are properly
seated on the slots.
4. Alignandrmlyinsertthetwo
CrossFireX™ bridge connectors to
thegoldngersoneachgraphicscard.
Ensurethattheconnectorsarermly
in place.
5. Connect three independent auxiliary
power sources from the power
supply to the three graphics cards
separately.
6. ConnectaVGAoraDVIcabletothe
graphics card.