Asus WS C422 SAGE/10G - Installing Four SLI-Ready Graphics Cards

ASUS WS C422 SAGE/10G
5-9
Chapter 5
4. Alignandrmlyinsertthe3-waySLI
®
bridgeconnectortothegoldngerson
each graphics card. Ensure that the
connectorisrmlyinplace.
5. Connect three independent auxiliary
power sources from the power supply
to the three graphics cards separately.
6. ConnectaVGAoraDVIcabletothe
graphics card.
3-way SLI
®
bridge
5.2.4 Installing four SLI-ready graphics cards
To install four SLI-ready graphics cards:
1. Prepare four SLI-ready graphics cards.
2. Insert the four graphics cards into the PCIEX16 slots. If your motherboard has more
than two PCIEX16 slots, refer to Chapter 1 in this user manual for the locations of the
PCIEX16 slots recommended for multi-graphics card installation.
3. Ensure that the cards are properly seated on the slots.
4. Alignandrmlyinsertthe4-waySLI
®
bridgeconnectortothegoldngersoneach
graphicscard.Ensurethattheconnectorisrmlyinplace.
5. Connect four independent auxiliary power sources from the power supply to the four
graphics cards separately.
6. ConnectaVGAoraDVIcabletothegraphicscard.
4-way SLI
®
bridge