Asus Z10PE-D8 WS - Me Firmware Force Recovery Setting (3-Pin Me_Rcvr1); Raid Selection Jumper Setting (3-Pin Raid_Sel1)

2-30
Chapter 2: Hardware information
4. RAID selection jumper setting (3-pin RAID_SEL1)
This jumper allows you to select the PCH SATA RAID mode to use LSI MegaRAID
software or Intel
®
 Rapid Storage Technology enterprise 3.0 RAID. Place the jumper
capsoverpins1–2ifyouwanttousetheLSIMegaRAIDsoftwareRAIDUtility(default);
otherwise,placethejumpercapstopins2–3tousetheIntel
®
RapidStorageTechnology
EnterpriseOptionROMUtility.
5. ME firmware force recovery setting (3-pin ME_RCVR1)
ThisjumperallowsyoutoforceIntelManagementEngine(ME)bootfromrecoverymode
whenMEbecomecorrupted.