EN 16
1. Fix the oven on both sides using screws.
2. After installation, remove the vinyl protective film from the door to
the appliance and the protective film from the interior surfaces of
the oven.
Connecting to the mains power supply
• Electrical connections must be made as per the connection plate
fixed to the back of the appliance by an electrical fitter who must
ensure that the appliance has been connected up in accordance
with fitting instructions and local regulations.
• Where the appliance is not connected to the mains electricity
supply by a plug, an omni polar cutout device (with a contacts
gap of at least 3 mm) must be fitted on the supply side of the
connection to meet safety requirements.
INSTALLATION AND CONNECTION
Live
Neutral
Earth
To Next Page
Loading...
Need help?
General
