EasyManua.ls Logo

Atag KU2590C - Cleaning the Appliance

Atag KU2590C
52 pages
Go to English
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
EN 22
MAINTENANCE AND CLEANING
Cleaning the appliance
Switch off the appliance and disconnect it from the mains before you start cleaning it.
Do not use abrasive cleaning agents, as they can damage the surface.
Activate the intensive freezing function 24 hours before you plan to clean the appliance.
Before cleaning, frozen foods should be wrapped in several layers of paper and kept in a
cool place. The inevitable rise in temperature will shorten their storage life. Remember to
use these foods within a relatively short period of time.
Regularly clean the interior of the appliance with lukewarm water. If so required, add a
neutral cleaning agent or special refrigerator cleaner to the water. Clean all surfaces with
a soft cloth. Wipe the cleaned parts with a cloth with clean water and then dry them
thoroughly.
Do not put parts of the appliance in a dishwasher: this could damage them.
Dry the inside of the unit, plug on the mains, and set the thermostat knob to the lowest
temperature setting. After 24 hours, set the thermostat to the normal position.
Clean the outside using a soft cloth.
Regularly clean the air vents of the appliance with a vacuum cleaner or a brush.
When you are not going to use the appliance for a longer period then switch it off and
disconnect it from the mains. Empty, defrost and clean the appliance, and leave the door
ajar.

Table of Contents

Related product manuals