Atag KU2590C - Faults Table; Troubleshooting

EN 23
Faults table
When you have any doubts about whether your appliance is working properly you should not
immediately assume that it is defective. We recommend that you should in any case check the
points in the following table.
Problem Cause or remedy
Appliance is connected to the
power mains but it does not
work.
• Make sure there is voltage in the power outlet and that the
appliance is switched on.
Cooling system operates
continuously for a long period
of time.
• The ambient temperature is too high.
• The door has been opened for too long or too frequently.
• The door is not closed properly.
• The door does not seal properly (the seal is dirty, the door
is misaligned or the seal is damaged, etc.).
• Too much fresh food has been put in at the same time.
• Insufcient air circulation around the compressor and
condenser. Check that the ventilation around the appliance
is sufcient (see the separate installation instructions).
Excessive ice formation in the
freezer.
• Freezer compartment is not periodically defrosted. Defrost
the freezer compartment to remove the ice.
• Door opened too frequently or too long.
• Door not properly closed.
• The door does not seal properly. If the seal is dirty or
damaged, clean or replace it.
The door does not open
easily.
• You are trying to open the appliance’s door just after
you have closed the door. Then opening the door is
difcult. When you open the door, cold air escapes
from the appliance and is replaced by warm air from the
surroundings. As this air cools a slight vacuum is created
that makes it more difcult to open the door. The situation
returns to normal after a few minutes, and the door opens
easily again.
TROUBLESHOOTING