What to do if my Atag Dishwasher doesn't start or stops during the cycle?
First, ensure the mains plug is properly connected to the mains socket. Also, check your fuse box to make sure there isn't a damaged fuse.
What to do if my Atag VA61111MT programme doesn't start?
First, make sure that the appliance door is completely closed. If the delay start function is activated, either cancel the setting or wait for the countdown to finish.
Why won't my Atag VA61111MT fill with water?
There are several possible reasons: * Ensure that the water tap is fully open. * Check that the water tap is not clogged. * Verify that the filter in the inlet hose isn't clogged. * Confirm that the inlet hose has no kinks or bends. If these steps don't resolve the issue, contact your local water authority to check the water supply pressure.
What to do if my Atag VA61111MT won't drain water?
Check to make sure that the sink spigot is not clogged and that the drain hose has no kinks or bends. If the anti-flood device is activated, close the water tap and contact the Service.
Why is my Atag VA61111MT Dishwasher releasing too much rinse aid?
Adjust the rinse aid selector to a lower position.
What to do if the released quantity of rinse aid is not sufficient in my Atag Dishwasher?
Adjust the rinse aid selector to a higher position.
The quality of the combi detergent tablets can be the cause. What should I do for my Atag VA61111MT Dishwasher?
Try using a different brand of combi detergent tablets.
General| Type | Freestanding |
|---|---|
| Number of place settings | 12 |
| Energy efficiency class | E |
| Noise emission class | C |
| Energy consumption per 100 cycles | 92 kWh |
| Annual Energy Consumption | 258 kWh |
| Noise Level | 47 dB |
| Drying Class | A |
| Number of Programs | 6 |
| Delay Start | Yes |
| Half Load Option | Yes |
| Dimensions (H x W x D) | 850 x 600 x 600 mm |
To Next Page
