Num‐
ber
Settings Values
Description
1)
5 Key tones 1F (on)
0F (off)
Activate or deactivate the sound of the but‐
tons when pressed.
Factory setting: 1F.
6 Latest pro‐
gramme selec‐
tion
1H (on)
0H (off)
Enable or disable the automatic selection of
the most recently used programme and op‐
tions.
Factory setting: 0H.
7 Display on
floor
1C (on)
0C (off)
Activate or deactivate the TimeBeam.
Factory setting: 1C.
1)
For more details, refer to the information provided in this chapter.
You can change the basic settings in
setting mode. Instructions on how to
configure the appliance are provided
further in this chapter.
When the appliance is in setting mode, the
display shows a digit and a letter. For
each setting, a dedicated letter is
displayed. The dedicated letters are
indicated in the table.
The order of the basic settings presented
in the table is also the order of the settings
in setting mode.
Setting mode
How to navigate in setting mode
You can navigate in setting mode using
programme buttons.
A. Previous button
B. OK button
C. Next button
Use Previous and Next to switch
between the basic settings and to change
their value.
Use OK to enter the selected setting and
to confirm changing its value.
How to enter setting mode
You can enter setting mode before
starting a programme. You cannot enter
setting mode while the programme is
running.
To enter setting mode, press and hold
simultaneously and for about 3
seconds.
The lights related to the Previous, OK
and Next are on.
How to change a setting
Make sure the appliance is in setting
mode.
1. Use Previous or Next to select the
desired setting.
The display shows the current setting
value (a digit and the dedicated letter).
2. Press OK to enter the setting.
The current setting value flashes.
3. Press Previous or Next to change the
value.
4. Press OK to confirm the setting.
• The new setting is saved.
• The appliance returns to the basic
settings list.
11
To Next Page
Loading...
Need help?
General
