Atag VA63211VT - Options; Multitab Option; Time Saver Option

• The display shows the current
setting: = Acoustic signal off.
3. Press to change the setting.
= Acoustic signal on.
4. Press the on/off button to confirm the
setting.
How to set the colour of the
TimeBeam
The appliance must be in programme
selection mode.
It is possible to change the colour of the
TimeBeam to match the colour of the
kitchen floor. There are several colours
available. The TimeBeam can also be
deactivated.
1.
To enter the user mode, press and hold
simultaneously and until the
indicators , , , and start
to flash and the display is blank.
2. Press .
• The indicators , , and go
off.
• The indicator continues to flash.
• The display shows a number and the
letter C. Each number refers to a
different colour.
– = TimeBeam deactivated.
3. Press again and again to change
the colour.
• You can see the different colours on
the kitchen floor.
4.
Press the on/off button to confirm the
setting.
OPTIONS
Desired options must be
activated every time before you
start a programme.
It is not possible to activate or
deactivate options while a
programme is running.
Not all options are compatible
with each other. If you have
selected non compatible
options, the appliance will
automatically deactivate one or
more of them. Only the
indicators of the options still
active will stay on.
Multitab
Activate this option when you use multi-
tablets that integrate the salt, rinse aid and
detergent functions. They can also contain
other cleaning or rinsing agents.
This option deactivates the release of salt.
The salt indicator does not come on.
This option also deactivates the release of
rinse aid but only when the rinse aid
dispenser is deactivated, (rinse aid indicator
does not come on). If the rinse aid
dispenser is activated, rinse aid is released
even with the option Multitab activated.
With the use of this option the programme
duration is prolonged to increase the
cleaning and drying results with the use of
multi-tablets.
Multitab is not a permanent option and
must be selected at every cycle.
How to activate Multitab
Press .
The related indicator comes on.
The display shows the updated programme
duration.
TIME SAVER
This option increases the pressure and the
temperature of the water. The washing and
the drying phases are shorter.
The total programme duration decreases by
approximately 50%.
The washing results are the same as with
the normal programme duration. The drying
results can decrease.
11