EN 16
INSTALLATION
Drilling the support surface and fitting the Hood
Warning!
Once the support surface has been drilled the hood canopy can be
installed in two ways:
• By inserting the hood canopy from below ( X = 106 mm ).
• By inserting the hood canopy from above ( X = 113 mm ).
Important
The minimum distance between the opening for the hob and the
one for the hood must be of at least 3-5 cm according to the
strength of the material used for the working top.
Inserting the hood canopy into the support surface from above
• Insert the brackets 7.2, as indicated in the figure, into the slots
provided and fix them with the screws 12a provided.
• The hood is built ready for front installation of the motor unit.
X
812
To Next Page
Loading...
