EN 21
Fixing the Lower Brackets
• Screw the brackets 7.1 to the front of the hood canopy using the
screws 12a provided.
• Before tightening the upper brackets completely, make all the
adjustments to allow them to rest on the lower base of the worktop
to avoid deformation of the upper brackets 7.2 as shown in the figure.
• With the aid of a spirit level, set the hood canopy level vertically and
fix it to the lower surface using 2 screws 12c provided.
• Tighten the screws 12a completely.
INSTALLATION
12a
7.1
12a
7.1
12c
To Next Page
Loading...
