5
Handling of this instrument (continued)
CAUTION
◇ When transporting the instrument, place it in its
original box.
◇ If the power switch is turned off and
immediately turned on, malfunction of the
instrument may occur. Wait one minute after
the instrument is turned off before switching
on again.
◇ Carefully read this instruction manual and fully understand the function and operation of each part of
the instrument before use.
◇ Check that each part of the instrument operates normally before use.
◇ Check the necessary operations such as zero setting according to the instruction manual.
◇ The manufacturer shall not be liable for any or all damages as a result of use of the instrument for
those other than its intended purposes (measurement of Brix, sugar content, concentration of liquid).
◇ The prism is a consumable item and is not covered under warranty. Special care should be taken to
avoid scratching or damaging the prism.
◇ Ensure that if use of the instrument has undesired effects on the consumption or application of the
measured materials, etc., ATAGO shall not be held liable for the results.
Handling of plug
WARNING
◇ Be sure to use the power cable included with
the RX-i series. If a power cable other than the
one included is used, the rated voltage and
polarity of the power may be different and may
cause smoking or fire.
◇ Do not insert the power plug in an outlet other
than AC100 to 240V.
◇ Do not use the power cable if damaged or broken. If used, fire, electrical shock, or burns may result.
For a new power cable, contact your Authorized ATAGO Distributor.
CAUTION
◇ Do not insert or disconnect the power plug with
wet hands.
◇ Be sure to hold and pull by the plug when
disconnecting the power cable from the outlet.
If the cable is pulled improperly, the plug may
be damaged, and result in fire or electrical
shock.
To Next Page
Loading...
Need help?
General
