4
Display screen messages
Continued on next page
AC FAIL There is no AC power to the set. If a good
battery is installed, basic phone operation (such
as making and answering calls on the handset)
is supported. Speakerphone, headset and call
privacy are not supported. The handset volume
will be at the minimum level and only the
two lowest levels of the ringer volume will be
available.
COVM The telephone is ready to receive a voice mail
signal from your local telephone company.
COVM
1 2 3 4
There are new voice mail messages.
DND The Do Not Disturb mode is on.
DTAD: XX/YY Flashes when the mailboxes of the DTAD mailbox
1080 t
elephone ar
e full or when the auto
attendant of the DTAD mailbox 1080 telephone
is off. (XX is the total number of new system
extension messages recorded for this 1070
telephone. YY is the total number of all system
extension messages recorded for this 1070
telephone.)
(EMPTY) The directory or one-touch location is empty.
EXT XX RING There is an incoming Centrex call.
FULL! The directory is full.
INITIALIZING. . The telephone is warming up after having its
power connected.
INTERCOM FROM XX The telephone is receiving a call from extension
XX (XX is the extension number).
(LIST EMPTY) The redial memory is empty.
LOW BATT There is no spare battery in the telephone or the
battery power is low.
LOWER The [LOWER] key is pressed to access and dial
the number stored in the lower section of a one-
touch key.
To Next Page
Loading...
