4.
Press and release 0 to make sure your system is on before you hang up.
Changing Your Announcement
To change your announcement:
1.
Dial your telephone number.
2.
When the system answers, enter your Remote Access code during or after the announcement.
3.
After you hear the 2 beeps,
press and release 4 *.
The system will beep and begin recording.
4.
Speak into the telephone
in a normal tone of voice.
5.
When you are finished,
press and release #.
The system automatically plays your new announcement.
To listen to your announcement again, press and release 4 1
after the 2 beeps
.
Bypassing the Announcement
People who call frequently can press * (on touch tone phones only) when the announcement begins. The
system skips the rest of the announcement, beeps, and begins recording.
Turning Off the System
Use the following procedure to turn off the system:
1.
Dial your telephone number.
2.
When the system answers,
enter your Remote Access code
during or after the announcement.
3.
After the 2-beep signal
press and release 8 8.
The system beeps twice. You can hang up and the system will not answer incoming calls until you turn it
on again.
To Previous Page
Loading...
Need help?
General
