1 Connect the line cord.
Plug one end of the telephone line cord
into the jack labeled TEL LINE on the
back of the system. Plug the other end into
a phone wall jack.
2 Connect the telephone.
NOTE: If you do not want to connect a
telephone, skip to Step 3.
Plug the line cord from the telephone into
the jack labeled TEL SET on the back of
the system.
3 Connect the power cord.
Plug the power cord into the jack labeled
POWER and into an electrical outlet not
controlled by a wall switch. Fit the power
cord behind the strain relief tab. The
Message Window flashes CL to indicate
that you need to set the clock.
Use only the power cord supplied with
this product. If you need a replacement,
call 1 800 722-9125.
INSTALLATION
!
To Next Page
Loading...
Need help?
General
