AT&T 1719 - Installation Guide; Before You Install; Turn System On;Off

INSTALLATION
Use only the power cord
supplied with this product.
If you need a replacement,
call 1 800 222–3111.
Input: 120 V, 60 Hz.
Output: 6V AC, 350 mA.
Modular
Telephone
Jack
Standard
Electrical
Outlet
1 Connect the
telephone
line cord.
2 Connect the
telephone
(optional).
Before You Install
Choose a location for the answering
system near a modular telephone jack and
a standard electrical outlet not controlled
by a wall switch.
NOTE: If you do not want to connect a
telephone, skip Step 2.
3 Connect the
power cord.
1
Turn System On/Off
Before proceeding to set up features,
press O to turn the system on. To
turn the system off, press O again.
When the system is off, the indicator
above the PLAY/STOP button is off and
the Message Window is blank.
Strain-relief
tab
NOTE: If the Message Window is blank
make sure the power cord is securely
connected to both the answering system
and an electrical outlet not controlled
by a wall switch. Press O to make
sure the system is on.