Message Window Is Blank
• Make sure the power cord is securely
connected (and threaded through the
strain relief tab) to both the answering
system and an electrical outlet not
controlled by a wall switch.
• Press O to make sure the system
is on.
Message Window Displays
Delete
–
Memo record
–
Telephone conversation record
CL Clock needs to be reset
––
System busy, in use or in remote
access mode
F Memory is full
CP System is copying a message from one
mailbox to another
System is busy
Power Failure Recovery
If the system is disconnected from AC
power it will not operate. Your
announcement and messages are retained
in memory during a power failure but you
will need to reset the clock. See the
instructions on the bottom of the unit.
If the message window displays CL, you
need to reset the clock. See the
instructions on the bottom of the unit.
10
IN CASE OF DIFFICULTY
To Next Page
Loading...
Need help?
General
