32
Appendix
This telephone is set up to comply with the energy-conserving standards right out of the box.
These instructions are intended for California Energy Commission (CEC) compliance testing
only. When the CEC battery charging testing mode is activated, all telephone functions, except
battery charging, will be disabled.
When rst purchased and properly installed for charging (see Battery installation and
charging on pages 10- 12), put the handset in the handset charger to charge. The CEC
battery charging testing mode is activated while charging.
If you have registered the handset to the BL102/BL102-2/BL102-3/BL102-4/BL102-5
base, below are the testing instructions.
To activate the CEC battery charging testing mode:
1. Unplug the telephone base power adapter from the power outlet. Make sure all
handsets are inserted with charged batteries before proceeding.
2. While you press and hold /HANDSET LOCATOR, plug the telephone base power
adapter back to the power outlet.
3. Aer about 20 seconds, when the IN USE light starts ashing, release
/HANDSET LOCATOR, and then press it again within two seconds.
When the phone successfully enters the CEC battery charging testing mode,
the IN USE light turns o and all handsets display To register HS... and see
manual alternately.
When the phone fails to enter this mode, repeat all the steps mentioned above.
To deactivate the CEC battery charging testing mode:
1. Unplug the telephone base power adapter from the power outlet, then plug it back in.
The telephone base is powered up as normal.
2. Register your handsets back to the telephone base. See pages 13-14 for handset
registration instructions.
California Energy Commission battery charging
testing instructions
To Next Page
Loading...
Need help?
General
