AT&T BL102-3 Quick Start Guide

10
Getting started
Battery installation and chargingBattery installation and charging
Once you have installed the battery, the screen indicates the Once you have installed the battery, the screen indicates the
battery status (see the following table). For best performance, keep battery status (see the following table). For best performance, keep
the handset in the telephone base or charger when not in use. The the handset in the telephone base or charger when not in use. The
battery is fully charged aer ten hours of continuous charging. See battery is fully charged aer ten hours of continuous charging. See
the table in the the table in the Technical specicationsTechnical specications section on page 101 for section on page 101 for
battery operating times.battery operating times.
Battery indicators Battery status Action
The screen is blank, or
shows Put in charger
and (ashing).
Battery has no or
very little charge. The
handset cannot be used.
Charge without
interruption
(at least 30 minutes).
The screen shows
Low battery and
(ashing).
Battery has enough
charge to be used for a
short time.
Charge without
interruption
(at least 30 minutes).
The screen shows
HANDSET X.
Battery is charged. To keep the battery
charged, place it in the
telephone base or charger
when not in use.
Step 1
Plug the battery connector securely into the socket inside the
handset battery compartment. Insert the supplied battery with the
label THIS SIDE UP facing up, as indicated.
THIS SIDE UP / CE CÔTÉ VERS LE
HAUT
Battery Pack / Bloc-piles :
BT183342/BT283342 (2.4V 400mAh Ni-MH)
WARNING / AVERTISSEMENT :
DO NOT BURN OR PUNCTURE BATTERIES.
NE PAS INCINÉRER OU PERCER LES PILES.
Made in China / Fabriqué en chine CR1535
THIS SIDE UP

AT&T BL102-3 Specifications

General

Brand	AT&T
Model	BL102-3
Category	Cordless Telephone
Language	English