40
Caller ID operation
Use the following steps to store the telephone
number of a call history entry in a two-touch
memory location.
When the telephone is idle, press CID/ to
enter the call history.
Press DIR/ or CID/ to scroll to the desired
caller ID entry.
Press MEM. The screen shows
ENTER LOCATION.
-OR-
If you need to add or remove the area code
or a 1 at the beginning of the number, do the
following:
Press SELECT continually to scroll through
the various dialing formats (area code +
seven-digit number, 1 + area code + seven-
digit number, seven-digit number or 1 +
seven-digit number).
Press MEM. The screen shows
ENTER LOCATION.
Press a dial pad key (0 through 9) to choose the
desired two-touch memory location to save the
displayed telephone number. The screen shows
STORED with a confirmation tone and then
returns to the call history.
Press FLASH to return to idle mode.
NOTES:
If there is no telephone number in the displayed
call history entry when you press MEM in step
3, the telephone plays an error tone.
If the two-touch memory location you selected
in step 4 above is occupied, the new telephone
number replaces the old one. Take caution not
to replace entries you do not wish to delete
from the two-touch memory locations.
1.
2.
3.
a.
b.
4.
5.
•
•
Storing a call history entry in a two-
touch location
12:00
AM
11-2016
15
CHRISTINE SMITH
888-722-7702
12:00
AM
11-20
15
STORED
12:00
AM
11-20
15
ENTER LOCATION
_
To Next Page
