Name: AT&T CL80113
Brand: AT&T
Rating: 4 (1 reviews)

To Next Page

To Previous Page

Registration and deregistration

Deregistering handsets

You may need to deregister your handsets if:

You have 12 registered handsets and need to replace a handset.

-OR-

You wish to change the designated handset number of your

registered handsets.

You must first deregister ALL the handsets, and then register each

handset you wish to use again, one at a time.

Please read carefully through all the instructions on this page

before beginning the deregistration process.

Deregister all handsets from your telephone base

1. Make sure that all handsets are out of the telephone base and

chargers before you begin deregistration.

2. Press and hold /HANDSET LOCATOR on the telephone base

for about ten seconds (until the IN USE light starts to flash). The

telephone base screen shows Registering... Please wait for five

seconds, then it shows Deregister all devices? Release

/HANDSET LOCATOR.

3. Immediately press /HANDSET LOCATOR again while the IN

USE light is still flashing. (If the light stops flashing, start again

with Step 1 above.)

4. It takes up to ten seconds to complete deregistration. Before

registering the handset again, wait for the cordless handset

screen to display To register HS, see manual.

5. To register the handset(s) to the telephone base again, follow the

instructions on pages 8-9.

NOTES:

If the deregistration process is not successful, you might need to reset the system

and try again. To reset, unplug the power from the telephone base and plug it back in.

You cannot deregister the handset(s) if any other system handset is in use.

Even if the battery is depleted, you can still deregister the handset by following

the steps above. After the handset is charged for at least ten minutes, the screen

shows To register HS, see manual.

•

Questions and Answers:

Need help?

Do you have a question about the AT&T CL80113 and is the answer not in the manual?

AT&T CL80113 Specifications

General