Answering system
4. Press qCID or pDIR to scroll to
#
of rings, then press
MENU/SELECT.
5. Press qCID or pDIR to choose among 2, 3, 4, 5, 6 or
Toll saver.
6. Press MENU/SELECT to save the setting. You hear a
confirmation tone.
NOTES:
If you subscribe to voicemail service through your telephone service provider,
see Answering system and voicemail indicators on page 62.
If you set the number of rings for the answering system as two or three rings, the caller ID
announce feature may not have enough time to announce the caller’s full information.
Remote access code
To access your answering system remotely from any touch-tone phone, you
need to enter a two-digit number (00-99). By default, the remote access code
is 19.
To change the remote access code:
1. When the handset is in idle mode, press MENU/SELECT to
enter the main menu.
2. Press qCID or pDIR to scroll to Answering sys, then
press MENU/SELECT.
3. Press qCID or pDIR to scroll to Ans sys setup, then
press MENU/SELECT.
4. Press qCID or pDIR to scroll to Remote code, then press
MENU/SELECT.
5. Use the dialing keys to enter a two-digit number. Press
MUTE/DELETE to backspace and delete a digit.
6. Press MENU/SELECT to save the setting. You hear a
confirmation tone.
•
•
Answering system settings
59
Call screening
># of rings
# OF RINGS
>4
REMOTE CODE
19
Answer ON/OFF
>Ans sys setup
Play messages
>Answering sys
To Next Page
Loading...
