Multiple handset use
Push-to-talk (PTT)
PTT call to a single device
1. There are a few ways to begin a PTT call to a single device.
When the handset is not in use:
If you have a two-handset system, press and hold
PUSH TO TAL�.
If you have more than two handsets:
w Press PUSH TO TAL� on the handset, then use the
dialing keys to enter the destination device number.
-OR-
w Press PUSH TO TAL� on the handset. Press qCID or
pDIR to highlight the destination device number, then
press MENU/SELECT or PUSH TO TAL�.
The handset shows Connecting to HANDSET X...
(HANDSET represents the handset name, X represents
the destination handset number).
When the connection is
made, both your and the destination device screens display
Press and hold [PTT] to talk.
2. Press and hold PUSH TO TAL�. A chirp indicates your
microphone is on. Speak towards the device. Your voice is
broadcast to the destination device.
While you are speaking, your handset shows
PTT To handset: X.
3. Release PUSH TO TAL� after speaking. Both devices beep once again and
the screens show Press and hold [PTT] to talk, then you can press and
hold PUSH TO TAL� to continue speaking or the destination device can
respond (see Answer a PTT call on page 36).
4. To end the PTT call, press
OFF/CANCEL or place the handset in the
telephone base or charger. The handset shows Push to talk Ended.
•
•
PTT To
handset: X
PUSH TO TALK
>HANDSET X
Connecting to
HANDSET X...
Press and hold
[PTT] to talk
34
To Next Page
Loading...
