60
Adding and registering handsets/headsets
Your telephone can support up to 12 DECT 6.0 cordless handsets (AT&T model
CL80103, sold separately) or up to 10 cordless handsets and 2 cordless
headsets (sold separately). Visit www.telephones.att.com/headsets
for a list of compatible DECT 6.0 cordless headsets. Each new handset or
headset must be registered to the telephone base before use. You must
register each handset or headset separately.
To register a cordless headset to this telephone system, please refer to the
user’s manual of the cordless headset for more details. To register a cordless
handset, see below.
The handsets provided within your product box are already registered as
HANDSET 1 and so forth. Additional handsets are assigned numbers in the
sequential order they are registered (up to HANDSET 12).
Register a handset to your telephone base
1. Before you begin registration, make sure the handset is
out of the telephone base or charger and shows To register
HS, see manual.
2. Put the handset you wish to register on the telephone
base cradle.
3. The screen shows Registering... Please wait and the
IN USE light turns on. It takes up to 90 seconds to
complete registration. Then HANDSET X Registered
appears on the screen, with HANDSET X being the
handset number (1-12). The handset beeps and the
IN USE light turns off. The handset is now registered
with the telephone base.
If registration fails, the system will automatically
try to register again. If registration fails after
the third try, Registration failed appears on
the screen for a few seconds, and then To
register HS, see manual. This may take up to
five minutes to occur. Please start again from
Step 1 above.
Appendix
Registering...
Please wait
HANDSET X
Registered
To register HS,
see manual.
For registration, put the handset
on the telephone base, not the
handset charger.
To Next Page
Loading...
