EasyManuals Logo

AT&T CL83464 User Manual

AT&T CL83464
141 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #109 background imageLoading...
Page #109 background image
Adding and registering handsets/headsets/speakerphones
Your telephone can support up to 12 DECT 6.0 cordless handsets (AT&T model
CL80114, sold separately) or up to ten cordless handsets and two cordless
headsets or speakerphones (sold separately). Visit
www.telephones.att.com/headsets for a list of compatible DECT
6.0 cordless headsets. Each new handset, headset or speakerphone must be
registered to the telephone base before use. You must register each handset,
headset or speakerphone separately.
To register a cordless headset or speakerphone to this telephone system,
please refer to the corresponding user’s manual for details. To register a
cordless handset, see below.
The handsets provided within your product box are already registered as
HANDSET 1, and so forth. Additional handsets are assigned numbers in the
sequential order they are registered (up to HANDSET 12).
Register a handset to the telephone base
NOTES:
Make sure the handset is out of the telephone base or charger and shows To register HS,
see manual.
When the telephone base prompts you to set the date and time, follow the instructions in
the user’s manual to set it or skip the setting by pressing CANCEL.
After the date and time setting is done or skipped, the telephone base will prompt if you want
to set up the answering system. Press MENU/SELECT to start the setup via voice guide or press
CANCEL to skip the setup. The telephone base now enters idle mode.
1. On the telephone base, press and hold /HANDSET
LOCATOR for about five seconds. Then, release the button
after the IN USE light turns on and the screen shows
Registering... Please wait.
2. On the handset, press QUIET # (pound key) immediately
and the screen shows Registering... Please wait.
3. When the registration process completes, HANDSET
X Registered appears on both the handset and the
telephone base screens ((HANDSET represents the
handset name, X represents the handset number). Both
the handset and the telephone base beep and the IN USE
light turns off. The handset is now registered with the
telephone base.
To register HS,
see manual.
Registering...
Please wait
HANDSET X
Registered
Appendix
103

Table of Contents

Other manuals for AT&T CL83464

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the AT&T CL83464 and is the answer not in the manual?

AT&T CL83464 Specifications

General IconGeneral
BrandAT&T
ModelCL83464
CategoryCordless Telephone
LanguageEnglish

Related product manuals