104
Answering system settings
Use the answering system menu of a system handset or
the telephone base to set up the announcement message,
turn on or o the answering system or message alert tone,
activate call screening, or change the number of rings,
remote access code or message recording time. If the
answering system is o when you change any setting in
the answering system setup menu, the answering system
automatically turns on.
1. When the device is in idle mode, press MENU/
SELECT to enter the
main menu.
2. Press
CID or DIR to scroll to Answering sys, then press MENU/SELECT.
Announcement
Your outgoing announcement plays when calls are answered by the
answering system.
The telephone has a default outgoing announcement, “Hello. Please leave a
message aer the tone.” You can use this announcement, or record your own.
You can record an announcement up to 90 seconds. The system does not
record any announcement shorter than two seconds.
To play your current outgoing announcement:
Using a cordless handset or the telephone base:
1. When the telephone is in idle mode, press MENU/
SELECT to
enter the main menu.
2. Press
CID or DIR to scroll to Answering sys, then press
MENU/SELECT.
3. Press
MENU/SELECT again to select Announcement.
4. Press
CID or DIR to scroll to Play annc, then press
MENU/SELECT.
>
Announcement
Delete all old
Record annc
>Play annc
Answering system
Play messages
>Answering sys
>
Announcement
Delete all old
Record annc
>Play annc
To Next Page
Loading...
Need help?
General
